Wires-Only ADSL – Asymmetrical Digital Subscriber Line

Wires-only was one of the first of many BT initiatives during 2002 designed to kickstart the adoption of broadband, appearing on a wholesale basis at the start of the year and reaching consumers via ISPs over the following months. Also referred to as self-install – because there is no need for a BT engineer to visit the subscriber’s premises at install time – wires-only instead requires that the subscriber purchase and fit a microfilter on every phone socket of the phone line with ADSL. Installed in pairs, these ensure that both signals – telephony and ADSL – can reside on the telephone line without interfering with one another. The low-pass filter separates the bottom 4KHz of the spectrum for conventional voice calls, faxes, modems and any other system that previously used the old audio system. The high-pass filter separates off everything between 4KHz and 1.1MHz for use by the ADSL digital channels. ADSL Micro-filters When the only option was for a BT engineer to install ADSL, these microfilters were fit at the primary linebox, making it necessary for the socket to be located close to the equipment to be connected to it if RJ11 extension cable runs were to be avoided. Modifying the primary linebox isn’t necessary with wires-only. Instead, the ADSL capability is carried to all sockets on a line, with each requiring the installation of a microfilter in order to use it. As well as being a lower cost option, wires-only packages afford technically competent subscribers with significantly greater flexibility. Not only do they not have to commit to a particular range of equipment or local network...

Pin It on Pinterest